Author Guidelines


Manuscripts should be submitted by one of the authors as e-mail attachment to: [email protected] or [email protected], the submitting author takes responsibility for the paper during submission and peer review.

Authors should also suggest information of three (3) qualified reviewers who have had experience in the subject of the submitted manuscript, but who are not affiliated with the same institutes as the contributor. At least two out of the three suggested reviewers should be from different countries.

Terms of Submission

Papers should be submitted on the understanding that they have not been published elsewhere (except in the form of an abstract or as part of a published lecture, review, or thesis) and are not currently under consideration by another journal.


Peer Review

All manuscripts are subject to peer review and are expected to meet standards of academic excellence.


Subdivision - numbered sections

Divide your manuscripts into clearly defined and numbered sections. Subsections should be numbered 1.1 (then 1.1.1, 1.1.2, ...), 1.2, etc. (the abstract is not included in section numbering). Any subsection may be given a brief heading and each heading should appear on its own separate line.


Title and Authorship Information

The following information should be included:

a. Paper title

b. Full author names

c. Full institutional mailing addresses

d. Email addresses



The manuscript should contain an abstract. The abstract should not exceed 250 words. Immediately after the abstract, provide a maximum of 6 keywords.


The Introduction should provide a clear statement of the problem, the relevant literature on the subject, and the proposed approach or solution. It should be understandable to colleagues from a broad range of scientific disciplines.


Materials and methods

This section should be complete enough to allow experiments to be reproduced. However, only truly new procedures should be described in detail; previously published procedures should be cited, and important modifications of published procedures should be mentioned briefly. 


Results and Discussion

The results and discussion should be presented with clarity and precision.



All acknowledgments (if any) should be included at the very end of the paper before the references and may include supporting grants, presentations, and so forth.



All references must be numbered consecutively and citations of references in text should be identified using numbers in square brackets (e.g., “as discussed by Zheng et al. [1]”; “as discussed elsewhere [2, 3]”). All references should be cited within the text; otherwise, these references will be automatically removed. References should be listed at the end of the paper.


1. Zheng H., Liu D., Zheng Y., Liang S., Liu Z., 2009. Sorption isotherm and kinetic modeling of aniline on Cr-bentonite. J. Hazard. Mater., 167, 141–147.


2. Mettam G.R., Adams L.B., 2009. How to prepare an electronic version of your article. In: Jones BS, Smith RZ, editors. Introduction to the electronic age, New York: E-Publishing Inc, pp 281–304.


3. Butland T.D., 2008. Adsorption removal of tertiary butyl alcohol from wastewater by zeolite. M.Sc. Thesis, Worcester Polytechnic Institute, Worcester.

Authors should use the IJCMER Manuscript Template to prepare their manuscripts.

Author Guidelines: PDF


Publishing high quality articles in all areas of Chemistry, Material and Environmental Sciences.

Chemists, Material scientists and Environmentalists

IJCMER welcomes the submission of manuscripts that meet the general criteria of significance and scientific excellence, and will publish: original research articles, case studies, critical reviews, surveys, commentaries and essays.


Nobel Prizes 2016